Our LTR 1100 combines the features of our telescopic cranes with those of our crawler cranes. For example, compared to conventional lattice boom crawler cranes with similar engine power, it features a shorter set-up time, easier transport and enormous flexibility in use. The crawler travel gear also delivers outstanding off-road capabilities and you can drive it with a load attached – even on constricted sites or at a lateral angle. The powerful boom has been taken from the telescopic crane and can be extended to any position and lengthened by jibs – to suit your requirements. The LTR 1100 also has great transport features – two standard low loaders are all that are required, and the crane erects itself at the site. That saves time and money.
The LTM 1070-4.2 features the very latest technology – ECOmode and ECOdrive reduce both fuel consumption and noise. The time-tested TELEMATIK single-cylinder telescoping system ensures that the telescopic boom can be extended to the required length easily and automatically. And the active, speed-dependent rear-axle steering enables the crane to drive off-road and makes it highly manoeuvrable. The 4-axle crane can also carried the majority of its ballast on the road. This means that it is immediately ready for use once it reaches the site. So the smallest of our 4-axle cranes is packed full of potential.
The LTM 1060-3.1 is designed for driving on roads with lots of ballast. A special method of dividing the ballast slabs has been included in the design of this mobile crane. This means that a wide range of driving configurations can be achieved quickly and easily. Its compact dimensions and time-tested ECOmode and ECOdrive make this mobile crane extremely economical to use. In addition to its compact size, the 3-axle crane features a long telescopic boom and impressive lifting capacities.
The LTM 1040-2.1 delivers outstanding lifting capacities over its entire operating range. Its long, 4-piece telescopic boom can be extended with infinite adjustment and quickly to any length using a time-tested hydro-mechanical telescoping system. The telescoping process can also be completed whilst there is a load on the boom. A folding jib can be used to achieve a radius of up to 39 meters. In comparison to the slightly smaller LTM 1030-2.1, this mobile crane can handle five tonnes more on its hook.
Harry Love
617-535-7689
